What you need:
  • Crystal Super headset
  • Screwdriver
  • DMAS (Left & Right)

Overview

  1. Peel Off the Foam Cover: Peel off the foam covering the earphone mounting holes on both sides of the headset.
  2. Remove the Default Earphones: Use a screwdriver to turn the screws counterclockwise and remove the original earphones.
  3. Align the DMAS Earphones: Insert the DMAS into the headset earphone mount, making sure the L (Left) and R (Right) labels are correctly aligned.
  4. Tighten the Screws: Once aligned, use the screwdriver to turn the screws clockwise to secure the earphones.
  5. Reattach the Foam: Don’t forget to stick the foam layer back over the earphone area after installation is complete.

Step by step

Step 1: Remove the Foam Cover

  • Peel off the foam covering the earphone mounting holes on both sides of the headset.

Step 2: Remove the Default Earphones

  • Use a screwdriver to turn the screws counterclockwise. Gently remove the original earphones and set them aside.

*Note: Be careful not to lose the screws — you’ll need them for the installation.


Step 3: Align the DMAS Earphones

  • Take the DMAS and align them with the headset's mounting points.

*Note: Each DMAS earphone is labeled L (Left) and R (Right) — make sure you install them on the correct side!


Step 4: Tighten the Screws

  • Once aligned, turn the screws clockwise to secure the DMAS to the headset. Make sure they’re firmly attached.

Step 5: Reattach the Foam Cover

  • After installation, don’t forget to stick the foam back over the headset.